Micom RM125R Uživatelská příručka stáhnout pdf (Strana 128)

MS-DMT Guide v1.04

Released 05-30-2014

128

Uses the proper CAT PTT ON and OFF commands for the

DATA port if CAT PTT is selected vs. Pins 6 (DPTT) and 8

(GND) of the KCT-39 cable for hardware PTT.

TT538

CAT PTT

57600, 8N1

Requires the “Enhanced PC Control" firmware v1.32 update

or later. The radio is being controlled in Jupiter mode, thus

full manual control is available.

TT538_DV

CAT PTT

57600, 8N1

Sent test build to AAM4SC. LINE selected for DATA TX and

back to MIC on RX, has potential of working.

TT563

CAT PTT

CPP – 19200, 8N1

Omni VI PTT is supported via Ten Tec extended command.

Radio Address is factory 0xE0h

TT564

CAT PTT

CPP – 19200, 8N1

Omni VI Plus. PTT is supported via Ten Tec extended

command.

Radio Address is factory 0x04h

TT586

CAT PTT

Paragon II. PTT is supported via Ten Tec extended command.

Radio Address is factory 0x2Ch

TT588

CAT PTT

57600 8N1

For use for OMNI VII TT588 and TT588AT in REMOTE MODE,

a new protocol that places the TT588 series radio into a

hands off operation by the user.

OMNI VII REMOTE MODE as documented in Model 588

Programmers Reference Guide Rev 1.0. To enter REMOTE

MODE hold down digit 2 on the band stack keyboard until

the firmware version string and REMOTE appears on the

display.

TT588_DV

CAT D/V

57600 8N1

Line Port selected before TX and MIC on RX

TT599

CAT PTT

57600 8N1

Also use for TT599AT and TT539.

1 2 ... 123 124 125 126 127 128 129 130 131 132 133 ... 139 140

Komentáře k této Příručce

Žádné komentáře

Micom RM125R Uživatelská příručka Strana 128

Komentáře k této Příručce